On this video we will be talking about the process to make a key for 2008 audi a6. The steps to make this key are:
-The removal of the J518 module from the vehicle, (hardest part of the process ) video on where we put it back will be attached.
-The extraction of the data from the J518, remember there’s 2 diagrams one for 2010 and up and one 2010 and below, we have seen 2010 and below cars with the newer diagram too.
-Once we read the information we will load the file into tango and select an open position and make a key. This key will be ready to start the car we will use a Megamos 8E Transponder.
-Final step is writing of response file from tango to J518 module with vvdi prog.
Course Instructor
Become a member today!(FREE ACCESS)
(FREE COURSE ACCESS FOR LIMITED TIME!) Just create an account and you will have access to this course!